SC-B9580 User's Guide Maintenance Replacing the Head Cleaning Set Replacement Procedure Always choose a replacement head cleaning set that is specified for this printer. Preparing and Replacement Timing U “Options and Consumable Products” on page 108 Before starting this procedure, be sure to read the following: is displayed in the wiper unit status display When The Head Cleaning Set is nearing the end of its service life. is displayed, or when U “Precautions Regarding Maintenance” on page 62 Prepare a new head cleaning set as soon as possible.
When you want to replace the parts at this stage due to night operations and so on, perform Replace Head Cleaning Set from the settings menu, and then replace the parts. If you replace them without performing Replace Head Cleaning Set , the head cleaning set counter will not operate correctly. A In the Head Cleaning Set is at the end of its service life. screen, press OK . If the message is not displayed, press (Maintenance), and then press Replace Head Cleaning Set . B Check the message, and then press Start . U “Maintenance Menu” on page 97 c Important: C Press How To... on the control panel screen to view the procedure and replace the part.
About the Head Cleaning Set Counter The printer tracks amounts consumed using the head cleaning set counter and displays a message when the counter reaches the warning level. Replacing the Media Edge Plates If you replace the head cleaning set according to the message Head Cleaning Set is at the end of its service life. , the counter is cleared automatically. If the media edge plates supplied with the printer become deformed or damaged, be sure to replace them with new ones. If you replace it before this message is displayed, be sure to do the replacement work from the settings menu. For replacement media edge plates, contact your dealer or Epson Support.
Contact your dealer or Epson Support. When Head Cleaning Set is at the end of its service life. is displayed c Important: See the following section, and replace all the parts included in the head cleaning set. Printing cannot be performed if the parts are not replaced. If you continue to use the printer with a deformed or damaged media edge plate, the print head could be damaged. The head cleaning sets contains the following parts. A Remove media, and turn off the printer. Check that the screen display has turned off, and then unplug the power cable from the outlet. ❏ Wiper unit (x1) ❏ Flushing pad (x1) U “Removing the Take-up Roll” on page 43 Disconnect both of the power cables. 67