CHECK TIRE PRESSURE The tires on yourtractor were overinflated at the factoryfor shipping purposes. Correcttire pressureis importantfor best cuttingperformance. Reduce tire pressure to PSI shown in "PRODUCT SPECIFICATIONS" on page 5 of this manual. CHECK DECK LEVELNESS ,/CHECKLIST PLEASE REVIEW THE FOLLOWINP_ CHECKLIST: / All assembly instructions have been completed. 4' No remaining loose parts in carton. / Battery is propedy prepared and charged. (Minimum I hour at 6 amps) Seat is adjusted comfortably and tightened securely. ,/ All tires are propedy inflated. (For shipping purposes, the tires were overinflated .at the factory).
,/ Be sure mower deck is properly level_ side-to-side/fFont-to-rear for best cutting results. (Tires must be properl! inflated for leveling). ,/ Check mower and drive belts. Be sure they are routed properly around pulle_ and inside all belt keepers. ,/ Check wiring. See that all connection,, are still secure and Wires are properly clamped. For best cutting results, mower housing should be properly leveled. See "TO LEVEL MOWER HOUSING" in the Service and Adjustments section of this manual. CHECK FOR PROPER POSITION OF ALL BELTS .... See the figures that are shown for replac- ing motion and mower blade drive belts in the Service and Adjustments section of this manual.
Verify that the belts are rout- ed correctly. CHECK BRAKE SYSTEM After you leam how to operate your trac- tor, check to see that the brake is properly adjusted. See "TO ADJUST BRAKE" in the Service and Adjustments section of this manual. WHILE LEARNING HOW TO USE YOUF TRACTOR, PAY EXTRA ATTENTION Tў THE FOLLOWING IMPORTANT ITEMS: 4' Engine oil is at proper level. ,/ Fuel tank is filled with fresh, clean, regular unleaded gasoline. ,/ Become familiar with all controls - thei location and function. Operate them before you start the engine. ,# Be sure brake system is in safe operating condition. 10