REPLACING BA'B'ERY INTERLOCKS AND RELAYS ,_CAUTION: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands,rings,etc. Positive terminal must be connected first Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting. Check wiring. See electrical wiring diagram in the Repair Parts section. TO REPLACE FUSE Replace with 15 amp automotive-type plug-in fuse. The fuse holder is located behind the dash. to prevent sparking from accidental grounding. Lift seat pan to raised position and open battery box door.
Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor. Install new battery with terminals in same position as old battery. First connect RED battery cable to positive (+) terminal with hex bolt and keps nut as shown. Tighten securely. Connect BLACK grounding cable to negative (-) terminal with remaining hex bolt and keps nut. Tighten securely. Close battery box door. TO REMOVE HOOD AND GRILL ASSEMBLY Raise hood. Unsnap headlight wire connector. Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor. To replace, reverse above procedure.
Hood Battery Box ligcht t Wire ENGINE Maintenance, repair, or replacement of the emission control devices and systems, which are being done at the customers expense, may be performed by any non-road engine repair establish- ment or individual. Warranty repairs must be performed by an authorized engine manufacturer's service outlet. TO ADJUST THROTTLE CONTROL CABLE It Positive Negative (Red) Cable (Black) Cable TO REPLACE HEADUGHT BULB Raise hood. Pull bulb holder out of the hole in the The throttle control has been preset at the factory and adjustment should not be necessary. Check adjustment as described below before loosening cable. If adjustment is necessary, proceed as follows:
backside of the grill. Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill. Close hood. With engine not running, move throttle control lever from slow to choke position. Slowly move lever from choke to fast position. 25