iii iiiii i 1,1,11 ill, iiii, i ii1,1 ...................................... ................... SERVICE AND ADJUSTMENTS TO REPLACE HEADLIGHT BULB ENGINE i q IIIIIHI III ....................................... I'1.................... I' I Raise hood TO ADJUST THROTTLE CONTROL CABLE Pull bulb holder out of the hole in the backside of the (See Fig. 30) grill° The throttle control has been preset at the factory and ° Replace bulb in holder and push bulb holder securely adjustment should not be necessary Check adjustment as back into the hole in the backside of the grill described below before loosening cable tf adjustment is Close hood necessary, proceed as follows:
INTERLOCKS AND RELAYS With engine not running, move throttle control lever to fast (,_) position Loose or damaged wiring may cause your tractor to run poorly stop running or prevent it from starting Check that swivel is against side of quarter circle If it is not, loosen cable clamp screw and pull cable back until swivel is against quarter circle° Tighten cabIe clamp screw securely Check wiring. See electrical wiring diagram in Repair Parts section of this manual TO REPLACE FUSE TO ADJUST CHOKE CONTROL (See Fig.
31) Replace with 30 amp automotive-type plug-in fuse° The fuse holder is located behind the dash The choke control has been preset at the factory and adjustment should not be necessary Check adjustment as described below before loosening cable If adjustment is necessary, proceed as follows: TO REMOVE HOOD AND GRILL (See Fig.
29) Raise hood With engine not running, move choke control (located on dash panel) to full choke (1\1) position Unsnap headlight wire connector , Remove air cleaner cover, filter and cartridge plate to expose carburetor choke (see "AIR FILTER" in the Customer Responsibilities section of this manual) = Stand in front of tractor Grasp hood at sides, titt forward and lift off of tractor To reinstall, slide hood pivot brackets into slots in frame° , Choke should be closed If it is not, loosen casing clamp screw and move choke cable until choke is completely closed Tighten casing clamp screw se curelyo , Reassemble air cleaner o Reconnect headlight wire connector and close hood CLAMP QUARTER CIRCLE HOOD HEADLIGHT WIRE CONNECTOR SWIVEL FIG.
30 CHOKE CLOSED FIG. 29 CHOKE CAS{NG CLAMP SCREW FIG. 31 23