ERVmCEA A USTMENTS TO REPLACE HEADLIGHT BULB Raise hood_ TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 33) Pull bulb holder out of the hole in the backside of the grill. o Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill, ° Close hood. . Raise hood. = Unsnap headlight wire connector,, ° Stand infront of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor. o To replace, reverse above procedures. INTERLOCKS AND RELAYS Loose or damaged wiring may cause your tractor to run poody, stop running, or prevent it from starting. , Check wiring.
See electrical wiring diagram in the Repair Parts section of this manual HEADLIGHT WiRE CONNECTOR TO REPLACE FUSE HOOD Replace with 30 amp automotive-type plug-in fuse. The fuse holder is located behind the dash. TO ADJUST ATTACHMENT LIFT SPRING (See Fig. 32) - While bottling spdng bushing withwrench, loosen jam nut° Turn adjustment bolt clockwise to extend spring and reduce lift effort for heavier attachments o Turn adjustment bolt counterclockwise for lighter at- tachments. ° Retighten jam nut against spring bushing. IMPORTANT; DO NOT ADJUST FOR MAXIMUM SPRING TENSION WHEN USING LIGHT ATTACHMENTS SUCH AS A MOWER° ADJUST LIFT LEVER SPRING TO AID IN LIFTING ATTACHMENT.
DO NOTOVERPOWER SPRING. WHEN REMOVING ATTACHMENT, ALWAYS ADJUST SPRING TENSION TO ITS LOWEST POSITION° FIG. 33 ENGINE ADJUSTMENT SPRING BUSHING BOLT TO ADJUST THROTTLE CONTROL CABLE (See Fig. 34) The throttle control has been preset at the factory and adjustment should not be necessary. Check adjustment as described below before loosening cable. If adjustment is necessary, proceed as follows: = With engine not running, move throttle control lever to fast position° ° Check that speed control lever is against stop screw. If it is not, loosen casing clamp screw and pull throttle cable until lever is against screw. Tighten clamp screw securely, ў ATTACHMENT JAM NUT LIFT SPRING FIG. 32 26