OOTaNG POINTS PROBLEM CORRECTION 1,1 Check wiring, switches and conne_onso if not corrected, contact an authorized service center/ department, ............. i , i, "ii ............... i1,1,1, Engine continues to run when operator leaves seat with attachment clutch 1,, Fault'y operator-safetyprL=sbnce control system, engaged Poor cut- uneven 1.. Worn, bent or loose blade, 2o Mower deck not level, 3, Buildup of grass, leaves, and trash under mower, 4. Bent blade mandrel., 5, Clogged mower deck vent holes from bu]Idup of grass, leaves, and trash around mandrels. 1.. Replace blade, Tighten blade boll 2. Level mower deck., 3. Clean underside of mower housing 4.
Replace blade mandrel 5 CEean around mandrels to open vent holes Mower blades will not rotate 1., Obstruction in crutch mechanism. 2_ Worn/damaged mower ddve belt. 3 Frozen idler pulley° 4. Frozen blade mandrel 1_ Remove obstruction,, 2. Replace mower drive belt, 3. Replace idler pulieyo 4. Replace blade mandrel Poor grass discharge 1., Engine speed too slow. 2, Travel speed too fasL 3 Wet grass. 4, Mower deck not level 5. Lowluneven tire air pressure. 6_ Worn, bent or loose blade. 7_ Buildup of grass, leaves and trash under mower_ 8. Mower ddva belt worn., 9 Blades Improperly installed_ 10. Improper blades used. 1t.
Clogged mower deck vent holes from buildup of grass, leaves, and trash around mandrels., 1. Place throtlle control in "FAST" position. 2_ Shift to slower speed, 3, Allow grass to dry before mowing° 4, Level mower deck. & Check tires for proper air pressure_ 6 Replacetsharpen blade_ Tighten blade bolt. 7,, Clean underside of mower housing. 8, Replace mower drive belt, 9,, Reinstall blades sharp edge down, 10,, Replace with blades listed in this manual 11,. Clean around mandrels to open vent holes. Headlight(s) not working (if so equipped) ,i ,,r , i i ,i I,Llll i 1, Switch is "OFF". 2, Bulb(s) burned out, 3. Faulty light switch. 4., Loose or damaged widng 5. Blown fuse.
ill i,l,, i,r, i, , ,lllll,lllll,i ii,, Io Turn swltch"ON",, 2, Replace bulb(s). 3. Check/replace light switch. 4, Check wiring and connections. 5,, Reptace fuse. , ,i ,,,',"H,, II 1, Bad battery ceil(s)o 2,, Poor cable connections,, 3_ Faulty regulator (if so equipped)_ 4. Fautty alternator,, 1. Replace battery,, 2, Checldclean aJl connections. 3, Reptace regulator_ 4. Replace alternator,, Battery wttl not charge Loss of drive 1., Freewheel contro!in "disengaged" postl_on. 2,, Motion drive belt worn, damaged, or broken,, 3. Air trapped in transmission during shipment or servictng_ I, Race freewheel control In "engaged" position 2, Replace motion drive belt 3. Purge transmission,, .........
ii I , i iiii1,, ills i ii ,,,,i "t,, Move throttle centre! to "SLOW" position and allow to idle for 30 seconds before stoppfng engine. i HI I1' ' II]_ Engine "backfires" when turning engine "OFF" 1, Engine throttle control not set at =SLOW" position for 30 seconds before stopping engine. _1/ I II IIIII I I I II 3O