1 Figure 6-28 Formatter pan assembly removal and replacement (2 of 4) CAUTION A small, flat-blade screwdriver should be used to release the top connector by pressing on the latch. Failure to use a flat-blade screwdriver to press on the latch will damage the connector. 12 Disconnect the ribbon cable from the DC controller shown in callout 1, Figure 6-29. 1 Figure 6-29 Formatter pan assembly removal and replacement (3 of 4) Note Although Figure 6-29 depicts the RFI shield still installed, make sure this shield was removed at step 7. 13 Remove the control panel cable from its cable stay, if necessary. 14 Remove the screws from the formatter pan assembly (shown in Figure 6-29 and Figure 6-30).
15 To remove the formatter pan, lift it slightly while pulling it out so that it clears the tabs. C7085-90921 Chapter 6 Removal and replacement 171