Contents Connections Playback Settings Tips Appendix o Dolby Sp.Setup Levels Set the distance between the Dolby Atmos Enabled speaker and the ceiling. Set the volume of the test tone to be the same at the listening position when it is output from each speaker. 0.90 m - 3.30 m / 3.0 ft - 11.0 ft (Default : 1.80 m / 6.0 ft) o Test Tone Start 0 This can be set when “Front Dolby” or “Surround Dolby” is set to “Large” or “Small” in “Speaker Config.”. A test tone is output from the selected speaker. While listening to the test tone, adjust the volume output from the selected speaker. o Set Defaults –12.0 dB – +12.0 dB (Default :
0.0 dB) The “Distances” settings are returned to the default settings. 0 The set “Levels” are reflected in all sound modes. 0 If you wish to adjust the channel level for each input source, carry out the settings in “Ch Level Adjust” ( v p. 107). 0 When headphones are connected to the PHONES connector on this unit, you cannot set “Levels”. o Set Defaults The “Levels” settings are returned to the default settings. Front panel Display Rear panel 181 Remote Index