Contents Connections Playback Settings Tips Appendix Wireless LAN When connecting to a wireless LAN network, stand the rod antenna for Bluetooth/wireless LAN connection upright on the rear panel. See “Wi-Fi Setup” on how to connect to a wireless LAN router. ( v p. 186) 0 When using this unit, we recommend you use a router equipped with the following functions: 0 Built-in DHCP server This function automatically assigns IP addresses on the LAN. 0 Built-in 100BASE-TX switch When connecting multiple devices, we recommend a switching hub with a speed of 100 Mbps or greater. 0 Only use a shielded STP or ScTP LAN cable (readily available at electronics stores).
(CAT-5 or greater recommended) 0 The normal shielded-type LAN cable is recommended. If a flat-type cable or unshielded-type cable is used, other devices could be affected by noise. 0 When using this unit connected to a network with no DHCP function, configure the IP address, etc. in “Network”. ( v p. 185) Internet Modem To WAN side 0 The types of routers that can be used depend on the ISP. Contact your ISP or a computer shop for details. 0 This unit is not compatible with PPPoE. A PPPoE compatible router is required if your contracted line is not set using PPPoE. 0 Do not connect a NETWORK connector directly to the LAN port / Ethernet connector on your computer.
0 Various online services may be discontinued without prior notice. NOTE Front panel Display Rear panel 61 Remote Index