Downloaded from https://www.everyspec.com MIL-HDBK-683(AT) 6.4.3 . Pm ~ The primary requirement for the data entry and display features of the sofiware ia that data can be entered and co~ted easily by an operator with limited statistical knowledge. Menus which lead the operator step by step to the point of entering the process data can facilitate the use of programs. Menu driven programs should have an option to ~reviate the start-up sequence in order to save time once the operator has becune f~ili~ with tb ~~=. Once the data haa been entered, the time to complete computathna and produce a result should be minimal.
The steps required for the machine to ~eaa the da- shall require little or m operator intervention to reaoh the conclusion. A further requirement for data entry ia that editing incorrectly entered data, after the initial calculations are complete, should be as simple as possible. Color can enhance graphic displays and add o~rator interest. The software, therefore, should supprt color monitors, even though this feature may not be used at all stations. 6.4.4 . Basic analysis needs for statistical data include the ability to construct histograms, Pareto diagrams and descriptive statistics such as average, standard deviation and range.
Histograms should be user controllable to allow specification limits to be superimposed on the collected data- This allows engineers and managers to quickly assess the magnitude of defective material likely to be produced if the process is allowed to continue under the conditions present during the study. Two sample histogram formata are ehown in figure 17-6. Pareto diagrams should b available as an analysis tool to help pick out the most significant contributors to a particular process or defect s~. The diagrams should display the cumulative percentage contribution of the elements in a straightforward manner, as well as, the percentage contribution of the individual elements.
A sample Pareto diagram is shown in figure 18-6 which illustrates the essential features. The descriptive statistics are available in almost all spreadsheet and data base management programs. More sophisticated programs may offer a wide range of additional statistics, but theee must be weighed carefdly if the added power complicates the operation of the software for day-to-day use. 6.4.5 The parameter Cp and Cpk are useful ratioa for comparing the improvements ~cie in a proceae over a period of time. They are easily computed in a software package if the specification limits, process average and standaxd deviation of the process are known.
$.4-5-1 ~- The Cp is the ratio of the engineering tolerance to the process capability and the software should provide this data along with an inte~retation along the following guidelines: 76