S UPER S ERVER 8060 Manual l SCSI Accessories One (1) internal and one (1) external 68-pin Ultra160 SCSI cable w/o active termination for SCA SCSI backplane One (1) set of SCSI driver diskettes One (1) SCSI manual l Two (2) TMR-008 CPU slot terminator cards* l Six (6) VRMs (Voltage Regulator Modules) You should also have received this User's Manual and several Supermicro diskettes, which contains various drivers and utilities. * Type and number depends upon the configuration ordered. 1-2 Server Chassis Features The SuperServer 8060 is a high-end, scaleable 4U rackmount server plat- form designed with today's most state-of-the-art features.
The following is a general outline of the main features of the SC860 chassis. System Power A triple redundant power supply consisting of three 300W units to provide 600W of continuous power with 300W of backup. If any one of the three power units fail you will be notified by alarm and LED, and the backup unit will automatically activate. These are hot-plug units that can be replaced without powering down the system. SCSI Subsystem The SCSI subsystem supports 4 80-pin SCA Ultra160 SCSI hard drives. (Any standard 1" drives are supported.
SCA = Single Connection Attach- ment.) The SCSI drives are connected to a SAF-TE compliant SCA backplane that provides power, bus termination and configuration settings. The SCSI drives are also hot-swap units. A RAID controller card can be used with the SCA backplanes to provide data security. Note: The operating system you use must have RAID support to enable the hot-swap capability of the SCSI drives. 1-2