Fusing element removal Figure 4-27 Metal Clips Holding Fusing Element Prior to this step: Remove the scanner, pods, printer door, front cover, memory card (if applicable), output roller, and delivery assembly. NOTE: Pay special attention to the way these metal clips are attached to the printer chassis before you remove them. This will make reassembly easier. The Fusing Element is held in place on each end by two metal spring-loaded clips. Each clip has a small black lever next to it. These levers must be in the “up” position. 1 Push each clip down and back, releasing it from the printer chassis. 90 Removal and Replacement C4224-90962