Shortcuts EN Table 15.1 Automatic setting Automatic setting function checks all channel signals and displays corresponding waveforms. Automatic setting determines the trigger source based on the following criteria. ⚫ If multiple channels input signals, choose the low frequency signal channel as the ⚫ If no signal is found, choose the lowest-numbered channel displayed as the trigger trigger source. source. ⚫ If no signal is found and no channel is displayed, the oscilloscope will display the CH1 channel and take it as the trigger source.
When the automatic setting function is used and the oscilloscope determines that the signal resembles a sine wave, the oscilloscope will display the following options: Table 15.2 Automatic setting of sine waves15 15.2 Default setting Click the Utility > Default . Click Default and the oscilloscope will display waveforms of the 4 channels. The following table shows settings for options, buttons, and controls under default setting. Copyright © Qingdao Hantek Electronics Co., LTD Tablet1000 User manual 63 Function Settings VOLTS/DIV Has been adjusted Waveform options Detailed instructions Multiple cycles Display multiple cycles with appropriate vertical and horizontal scales.
Single cycle Set the horizontal scale to display a period of the waveform. Automatic range Automatic setting. Data source Select the data source: Display the current channel only or display all channels. Cancel Restore the oscilloscope to previous settings. Menu or system Options, labels or knobs Default settings Acquisition Mode Normal Running state Run/stop Run Cursor State OFF Display Type Vector Afterglow OFF Mode YT Horizontal Window mode Single window