Chapter 5 Setting the Printer Driver ❏ The following table shows the recommended value for the 2D symbol module. • Recommended value for setting the barcode/2D symbol font (2D symbol of stack type) - : Not supported. * 1 : Whether paper feed is performed during printing 2D symbol can be checked in [Display Media Feed Position] - [Display Print Preview] in the Print Preview function. For this function, see "Print Preview" on page 90 . 5 *2: Specify when using PDF417.
83 Symbol Category Print Quality Print Status *1 Adjust Bar Width *2 Minimum Module [by 360 dpi] ANSI Grade D or higher ANSI Grade C or higher ANSI Grade B or higher • PDF417 • GS1 DataBar Stacked • GS1 DataBar Stacked Omnidirec- tional • GS1 DataBar Expanded Stacked Plain Media, Plain Media Label Speed No Paper feed 3 6 dot - - With Paper feed 6 dot - - Quality No Paper feed 6 dot - - With Paper feed 6 dot - - Fine Media, Fine Media Label, Syn- thetic Media Label, PET Film, Wrist Band Speed No Paper feed 4 dot - - With Paper feed 4 dot - (*2) - Quality No Paper feed 4 dot - - With Paper feed 4 dot - (*2) -