Chapter 4 Handling Setting Check Modes Besides the ordinary print mode, the printer has the self-test mode and allows you to print the status sheet (Ethernet model only) to check the various settings of the printer. Self-test Mode Printing errors such as dot missing can be checked on self-test mode. In addition, the firmware version, Post- Printing Verification Settings, and media position detection setting can be checked. Follow the steps below to run the self-test. 1 Set the die-cut label, receipt or continuous label which length is 90 mm or more. 2 Turn the power on while pressing the paper feed button.
(Keep pressing the Power switch until the POWER LED is on.) Following test pattern is printed. Firmware Version Post-Printing Verification Setting Number of Cut Media Position Detection 4 189