Chapter 1 Product Overview Status/Error Indications The printer status is displayed with combination of lighting and flashing of LEDs. When an error occurs, you can find out the cause and the remedy from the LED indication for the error. / : Lights / : Flashes : Off — : No change 1 19 LED Status Remedy Power Error Ink Paper — — — Power on — — — — Powering off Charging ink Closing roll paper cover Saving or printing data — AID temperature error The ambient temperature may be too low or too high. Turn OFF the printer power, and turn the printer ON in a location with an ambient temperature of 10 to 35°C.
(See "Environmental Conditions" on page 57.) Maintenance requirement The printer needs repair. Unrecoverable nozzle clogging error (Missing Dot Acceptable Print Mode) This condition occurs when turning on the printer after a fatal error resulting from unrecoverable nozzle clogging. In this mode, printing is performed even with a missing dot. The printer needs repair. (See "When an Unrecoverable Missing Dot Occurs" on page 24.) Fatal error 1. Turn the power off. 2. Open the roll paper cover and remove the jammed paper if any. (See "Removing Jammed Paper" on page 151.) 3. Turn the power on. If the same error persists, the printer needs repair. Cutter error —