Chapter 5 Maintenance of the TM-C3400 Setup Procedure The setup procedure from the printer installation to ready-to-print status is described below. 1 Install the printer. ( page 65 ) 2 Connect the power supply unit. ( page 66 ) 3 Load the roll paper included in the package in the printer. ( page 85 ) 4 For Ethernet model, connect the printer to the network. ( page 70 ) 5 Load the ink cartridge. ( page 67 ) Turn on the printer before loading the ink cartridge. It takes about 8 minutes for ink charging. When ink charging finishes, the POWER LED stops flashing and stays on. 6 For the Ethernet model, make the network settings such as IP address to the printer with EpsonNet Config.
7 For the USB model, connect the printer to the client computer. ( page 69 ) Turn off the printer before connecting it to the client computer. 8 Install the printer driver (the install package) on the client computer, and make the set- tings for it. 9 For the USB model, install the Printer Setting to the client computer. 5 10 For the Ethernet model, install Printer Setting on a computer that can access the printer (administrator computer or client computer). 11 Use Printer Setting on a client computer or administrator computer to configure the printer. 12 Set the DIP switches of the printer. ( page 78 ) Turn off the printer before setting the DIP switches. 13 Load the paper.
( page 80 ) Set the paper according to the DIP switch setting. 14 Perform a test print. 217