3. Loosen the detector adjustment screw using a coin or similar tool. Detector adjustment screw 4. The adjustment position of the roll paper Near-End detector changes depending on the way of installation. In either case (vertical or horizontal), adjust the detector so that its tab comes out from the hole near the bottom of the printer. (Refer to "Adjusting Roll Paper Near-End Detection Position" on page 25 , "Adjustment Positions of N.E. Detector" on page 27 . Move the N.E. detector holder in the direction of the arrow to make the detector come out from the window for either vertical or horizontal installation. Note: When changing the position of the N.E.
detector in accordance with the change of installation, move the roll paper N.E. detector as the above arrow shows while holding down the detector. 26 Setup