TM-P60 Technical Reference Guide A 5.5 Reset the TM-P60 device to its default settings. Reset the TM-P60 to its default settings. (See “Resetting the Printer” (page 3-4)). Reset all communication settings after doing so. (See “Setup” (page 2-1).) A 5.6 There is a problem with the host device. If available, replace the host device with another functioning host device. Q6. I cannot create a TM-P60 Bluetooth serial connection. A 6.1 Match the host device and TM-P60 communication settings. Run a TM-P60 self test to confirm the settings. Make sure that the TM-P60 and host device settings match. A 6.2 After checking that the serial cable (OT-RS60) is connected, turn on the TM-P60.
Check that the TM-P60 is connected to the PC with a serial cable (OT-RS60), and then turn on TM-P60 power again. A 6.3 The serial cable is not a type specified by EPSON. Use a serial cable type specified by EPSON. We cannot guarantee communication when a cable other than the one specified (OT-RS60) is used. A 6.4 TM-P60 power is not on. Turn on power to the TM-P60. Q7. The device is disconnected from the network after connecting for several minutes. A 7.1 The host device may be using a power management or suspend function. Check that the power management and suspend functions on the host device are turned off. Q8. Power to the TM-P60 shuts off after being on several minutes.
A 8.1 The TM-P60's automatic power off interval is incorrectly set. If an “Automatic Power Off Interval” is set for the memory switch, the TM-P60 will automatically shut off in no data is received during the specified interval. Check the TM-P60’s power management function. (See “Memory Switches” (page 2-15).) Q9. I cannot print. A 9.1 TM-P60 power is off. Turn on power to the TM-P60. A 9.2 Power shuts off during printing. The battery has no charge. Replace or charge the battery, or plug in the AC adapter. Rev. C FAQ D-3