EpsonNet Config (Web Version) EpsonNet Config (Web version) is a utility to configure the network and other settings on a web browser. Starting EpsonNet Config (Web Version) Follow the steps below to start up EpsonNet Config (web version). 1 Start up a PC connected to the network. 2 Start up the web browser and input the printer’s IP address (http://printer’s IP address) in the address bar as shown below. http://xxx.xxx.xxx.xxx You can check the printer's IP address using the dynamic status sheet or in self-test mode. For details on printing the dynamic status sheet, see "Dynamic Status Sheet Print Mode" on page 66 . For details on the self-test mode, see "Self-test mode" on page 57 .
In the initial setting, the user name and password will be required on the authentication screen when you access EpsonNet Config (web version) from a browser. The settings for the user name and password are as follows. The default setting for the password varies depending on the Wi-Fi model's firmware version. You can check the Wi-Fi model's firmware version using the self-test. ( "Self-test mode" on page 57) You can check the product's serial number using a self-test or on the manufacturing nameplate attached to the product. ( "Self-test mode" on page 57) You can change the password in [Password] in the Optional configuration menu.
68 Wi-Fi model's firmware version User name Password Before 1.30 "epson" "epson" 1.30 or later "epson" Product serial number (10 alphanumeric characters, case sensitive)