Chapter 1 Product Overview Confirmation Mode Use this mode to specify processing conditions from the application. This mode stops the process that starts with cut sheet feeding is from the ASF and ends with cut sheet output to a pocket, in order to receive an instruction from the application. It then restarts the process. It also can be used to configure the no-overlap/overlap setting from the application. No-overlap: Starts send of the next cut sheet after the current cut sheet is fully in the pocket Overlap:
Starts feeding of the next cut sheet while the current cut sheet is being output to the pocket Document Processing Sequence The processing sequence depends on the number of pockets and whether or not back feeding or overlap is being performed. With overlap When back feeding is not necessary with 1-pocket models/2-pocket models 1 Fed from the ASF Check for double feeding MICR reading Ink jet printing Capturing image on both sides Stop of paper feeding* Ejection of the cut sheet Fed from the ASF ∗ Waits for a command from the application. Check for double feeding Stop of paper feeding* Ejection of the cut sheet Fed from the ASF 27