Appendix Printable Area The maximum printable area of paper with a width of 79.5±0.5 mm {3.13±0.02"} is 72.0±0.2 mm {2.83±0.008"} (576 dots) and the approximate space is 3.75 mm {0.15"} on the left side and 3.75 mm {0.15"} on the right side. 79.5±0.5 mm 3.75 mm 3.75 mm Printing and Cutting Positions Manual-cutter position Approx. 27.1 mm Autocutter blade position Center of the print dotline Printable area Paper feed direction The values above may vary slightly as a result of paper slack or variations in the paper. Take this into account when setting the cutting position of the autocutter.
When removing cut paper, the remaining roll paper is pulled at the uncut section and the pitch of the next print may be reduced. When printing after cutting paper for prints with no pitch reduction, feed the paper about 1 mm {16/406 inches} before printing. When leaving paper loaded for an extended period of time, make sure you feed about 40 mm of paper. This can prevent paper from wrinkling and causing prints to be too light. 64 72.0±0.2 mm Approx. 10.5 mm Approx. 10.5 mm