Chapter 2 Setup USB power-saving function • Disabled • Enabled (initial setting) The USB power-saving function is valid only when the USB interface communication condition is set to the vendor-defined class and the system configuration is set so that the USB driver can support the USB power-saving function. Release condition of receive buffer BUSY • Releases when the remaining receive buffer capacity becomes 256 bytes (initial setting) • Releases when the remaining receive buffer capacity becomes 138 bytes Roll paper width • 80 mm (initial setting) • 58 mm 2 • To change the paper width, you need to install the 58-mm width paper guide plate.
For information about how to change the paper width, see "Changing the Paper Width" on page 36 . • Because some parts of the print head and the autocutter contact the platen and they may become worn out, once you change the paper width from 80 to 58 mm and use the printer, you cannot change it back to 80 mm. Setting the print density Selectable from levels 1 to 7 (85 ∼ 115%). Initial setting: level 4 (standard) Depending on the paper type, it is recommended to set the print density as shown in the table below for the best print quality. When the print density level is increased, printing speed may be reduced.
45 Original Paper type Density Level TF50KS-E, TF60KS-E, PD150R, PD160R, PD190R, P220AGB-1, P300, P310, P350, AF50KS-E, KT55F20, KT48F20 4 (100%) F5041 5 (105%)