Appendix Default administrator password for setting When using the network interface on UIB, refer to the UIB’s Technical Reference Guide. The default password varies depending on the password label and the firmware version. The password label is attached to the bottom of the printer. Example of the password label: You can check the product's serial number using a self-test ( "Self-test Mode" on page 70 ) or on the manufacturing nameplate attached to the product. You can check the firmware version using a self-test ( "Self-test Mode" on page 70 ). If the password label is lost, the default password can be checked by printing the status sheet.
(If there is no password on the status sheet, the default password depends on the firmware version.) To improve security, it is recommended to change the administrator password from the default password. The password can be changed using EpsonNet Config (Web version), TM-T88VI Utility, or Epson TM Utility. 133 Password label Firmware version Password Attached on the product - Printed on the label Not attached on the product Before 40.52A/40.52B ESC/POS "epson" 40.52A/40.52B ESC/POS or later Product serial number (10-digit alphanumeric characters, case-sensitive) * * * Wi-Fi & Ethernet Interface * * * Wi-Fi Status MAC Address : Unmounted : : Ethernet Status MAC Address : XX-XX-XX-XX-XX-XX : :
Network Soft Version : XX.XX TCP/IP Status Acquiring : Auto : : Service Status Time Server (of)f : : Other Status Date/Time : 20XX/XX/XX 00:00:00 Wi-Fi Device ID : Unknown Wi-Fi Region ID : 0 Initial Password XXXXXXXX