Chapter 3 Advanced Usage • When the print density level is increased, print speed may be reduced. When printing at a density of 115% or more and below a room temperature of 15°C, the speed drops to less than 200 mm/sec. • When setting the print speed to level 14, use customized values to set the print density. Print speed Selectable from levels 1 to 14 (Slow ~ Fast) Default setting: level 13 • Print speed is restricted by the settings for the number of head electrification divisions. The maximum printing speed of 350 mm/s is only possible when 1 electrification division is selected. • The maximum printing speed when using 58 mm is 300 mm/s.
Depending on print conditions, such as print duty, print head temperature, and data transmission speed, print speed is automatically adjusted, which may cause white lines due to intermittent print (the motor sometimes stops). To avoid this, keep the print speed constant by setting it lower. Column emulation mode • Standard mode (default setting) 3 • 48 column mode This function is supported only on the ANK model. Print density during multi-tone printing Selectable from 70 to 130% (5% increment) Default setting: 100% Power supply output Selectable from levels 1 to 3 low power load Default setting:
level 3 Paper width • 80mm (default setting) • 58mm Interface selection • Fixed to UIB • Fixed to built-in USB • Fixed to Ethernet (Wi-Fi) • UIB/Bluetooth 65