Resetting the Interface Settings Follow the steps below to restore the interface settings to the factory default. • You can return the interface settings to their defaults from the Interface Setup mode. See "Interface Setup Mode" on page 76 for details on the Interface Setup mode. • Only network settings are returned to their defaults. 1 Turn off the printer and close the roll paper cover. 2 If the connector cover is attached, remove the cover. See "Attaching the Connector Cover" on page 46 for details on removing the connector cover. 3 Hold down the status sheet button while turning on the printer. A message is printed indicating that resetting is being performed, and the printer restarts.
Hold down the status sheet button until the initialization execution message is printed. 84