2. PRINTER SETUP ENGLISH VERSION EO1-33097 2.7 Loading the Media 2.7 Loading the Media This section describes how to load the media in the printer. This printer accepts label rolls, tag rolls, and fanfold paper stocks. Please use TOSHIBA TEC CORPORATION approved media. NOTES: 1. Please perform a media sensor calibration whenever you change the media type. 2. The size of the media which can be loaded inside the printer is as follows: Outer roll diameter: Max. 127mm (5”) Inner core diameter: 25.4 (1”) mm or 38.1 mm (1.5”) When the outer roll diameter exceeds 127 mm or the inner core diameter exceeds 38.1 mm, an optional External Media Stand is required.
For details, refer to the Installation Manual for the B- FV904-PH-QM-R External Media Stand . At factory shipment, the core holder size is set for 1.5” on the Media Roll Holders. If you want to use 1” core media, detach the core holders by loosening the thumb screws, reverse the core holders then re-attach them with the thumb screws to the Media Roll Holders as shown below. WARNING! 1. Do not touch any moving parts. To reduce the risk of fingers, jewellery, clothing, etc. being drawn into the mechanism, be sure to load the media only once the printer has completely stopped moving. 2. To avoid injury, be careful not to trap your fingers while opening or closing the Top Cover. CAUTION!
Be careful not to touch the Print Head Elements when opening the Top Cover. Doing this may cause damage to some of the dots through static discharge or other print quality problems. Core Holder 3. Media rolls can be wound inside or wound outside. (See the diagram below.) Both types of media roll should be loaded so that the print side faces up. E2-7 Outside wound Inside wound