Chapter 3 Interface Introduction 5. Digital I/O TP70P-211LC1T is with 17 input points and 24 output points. You have controls over individual points and you can also read the status of the input points under this setting item. 6. System Setup In the past, you need to press the RESET button to enter the System Setup page. Now you can also find System Setup page on the main setting menu. You can set up the percentage of the backlight, how long the brightness dims out and many more. 3.1.1 Load Cell Setup Press Load Cell Setup from the main setting menu to display its corresponding setting page. You can always press 3_ in the upper right corner to return to the main setting menu.
There are 10 setting items for you to set up. Press in the upper left corner to save the settings after each setup or the changes will not be saved. (1) Sensibility (V) : set up the excitation voltage at the load cell, ranging from 2.0 V to 9.5 V. (2) Eigenvalue Mode : set up the eigenvalue mode from 1 to 9; the excitation voltage in different eigenvalue modes corresponds to different eigenvalues. See the table below for reference. 3-3