User Manual of EM730 Series Inverter function codes F02.31 to F02.36. 100.00% is the percentage to the set value of F00.16 (maximum frequency). F00.04=5: High-frequency pulse input (X5) The main frequency source A depends on the HDI (percentage) * F00.16. The terminal X5 can also be used for high-frequency pulse input (set the terminal function F02.04 to “40: pulse input”), with the frequency of 0.00-100.00kHz and voltage of 12-48V. The corresponding percentage of terminal input pulse frequency is set by F02.06-F02.29. 100.00% is the percentage relative to the set value of F00.16 (maximum frequency). F00.04=6 or 7:
main frequency communication setting The main frequency source A depends on the communication, etc. If the master-slave communication (F10.05=1) is enabled and the inverter works as the slave (F10.06=0), the main frequency source A is set to “700FH (master-slave communication setting) * F00.16 (maximum frequency) * F10.08 (slave receiving proportional coefficient)”, and the 700FH data range is -100.00% to 100.00%, as detailed in Table 12-31 . For general communication (F10.05=0): a 、 F00.04=6 percentage setting:
the main frequency source A is set to “7001H (communication percentage setting of the main channel frequency A) * F00.16 (maximum frequency)”; b 、 F00.04=7 direct frequency setting: the main frequency source A is set to “7015H The 7001H data range is -100.00% to 100.00%, and the 7015H data range is 0.00 to (communication setting of the main channel frequency A)” F00.16 (maximum frequency), as detailed in Table 12-31. F00.04=8: digital potentiometer setting In the speed mode, the main frequency source A is set directly by the digital potentiometer, and only the monitoring interface is available. See F12.42 for the specific value. Operating instructions for the digital potentiometer:
In the monitoring interface, turn the digital potentiometer clockwise or counterclockwise to increase or decrease the set frequency. This is the editing status, and the value will flash if changed. After the change is made, press the ENTER key to exit the editing status. The indicator will no longer flicker. Or, After the modification is complete, press ESC to return to the One-level menu interface. The previously modified value is still valid. See the running monitoring of keyboard operation. 153