3-7 Parameter List 3 Operation * 2nd control is displayed when '08 (2nd control)' is allocated to one of multi-function inputs from C001 to C006. 3-31 Parameter No. Function name Monitor or data range (Digital Operator) Default setting Changes during operation Unit Page Multi-function output setting C021 Multi-function output terminal P1 selection 00: RUN (signal during RUN) 01: FA1 (constant speed arrival signal) 02: FA2 (over set frequency arrival signal) 03: OL (overload warning) 04: OD (excessive PID deviation) 05: AL (alarm output) 06: Dc (disconnection detected) 07: FBV (PID FB status output) 08: NDc (network error) 09: LOG(logic operation output) 10:
ODc(communication option disconnected) 00 No 4-53 C022 Multi-function output terminal P2 selection 01 C026 Relay output (MA, MB) function selection 05 C028 AM selection 00: Output frequency 01: Output current 00 No 4-31 4-62 C031 Multi-function output terminal P1 contact selection 00: NO contact at MA; NC contact at MB 01: NC contact at MA; NO contact at MB 00 No 4-60 C032 Multi-function output terminal P2 contact selection 00 C036 Relay output (MA, MB) contact selection 01 Level output status setting C041 Overload warning level 0.0:
Does not operate 0.1 × Rated current to 2.0 × Rated current Rated current No A 4-29 4-55 C241 *2nd overload warning level Rated current 4-29 C042 Arrival frequency during acceleration 0.0 to 400.0 0.0 No Hz 4-54 C043 Arrival frequency during deceleration 0.0 to 400.0 0.0 No Hz 4-54 C044 PID deviation excessive level 0.0 to 100.0 3.0 No % 4-19 4-56 C052 PID FB upper limit 0.0 to 100.0 100 No % 4-19 C053 PID FB lower limit 0.0