may be extremely hot or cold depending on the seasons, exposing occupants to a high risk of injury and illness, and even death, es- pecially affecting children. DANGER Diameter of 20mm battery or other lithium battery accidentally swallowed or stuck into the trachea, in a short time can make people suffocate or serious injury, even death! ● Never remove the key from the ignition lock while the vehicle is in motion. Otherwise, the steering lock may engage and you will no longer be able to steer the vehicle. This can result in accidents and serious or even fatal injuries. ● Keep keys, key rings, batteries, spare batter- ies, and other batteries larger than 20mm in diameter safe from children.
● If the key cover plate cannot be pressed back, do not use the remote key. Every car key contains electronic components, so keep them safe from damage, moisture and strong vibration. NOTICE ● If a battery is swallowed by mistake, seek medical attention as soon as possible. NOTICE NOTICE ● Improper battery replacement may damage vehicle keys. Frequent use of the comfort and convenience feature or unnecessary pressing of the key but- ton will accelerate the battery drain in the key. ● The use of inappropriate or non-compliant batteries may damage vehicle keys. Only new batteries of the same rated voltage, size, and specifications can be used to replace the dead batteries.
● Make sure to install the battery as described above. Key damage due to battery replace- ment is not covered by quality guarantee. Replace batteries Waste batteries must be disposed of in strict accordance with the relevant provi- sions of the Environmental Protection Law. Vehicle key synchronization processing Fig. 41 Vehicle keys: Replace button batteries If the remote key can no longer be used to open or lock the vehicle, synchronize the vehicle key or replace the button battery → page 52. Fig. 41 jump leads: – Turn the head of the key. 1 2 Cover plate Button battery – Remove driver's side door handle cov- er → page 56.
It is recommended that you change the button battery at the qualified workshop → . – Stand near the vehicle. – Turn the head of the key. – Press the button on the key . – Unlock the vehicle with the vehicle key. – Remove button battery 2 from battery case. – Pry up key cover plate 1 → . – Install the driver's side door handle cov- er → page 56. – Place the new button battery in the battery case → . Key synchronization is complete. – Press the cover plate 1 back onto the key housing and clamp it. Owner's manual 52