Headlamp lighting range adjustment can provide you with detailed information and this work should be carried out by the qualified workshop. The method of blocking and adjusting the headlight may only be used temporarily. Permanent changes to the headlight settings may be made by contacting Volkswagen dealer- ship, who shall make permanent changes to the headlight settings. Interior lighting WARNING Instrument and switch lighting If the headlight is adjusted too high or the use of main beam is improper, it may have blinding effect on the drivers of other vehicles on the road, distracting their attention, which is very easy to cause serious casualties!
When the light switch is in position , the sen- sor automatically detects the ambient brightness level and switches the dipped beam and the lighting in the instruments and switches on and off. ● Be sure to adjust the headlamp correctly so that it is always properly lit. ● Do not switch on headlight main beam or headlight flasher if it may cause blinding ef- fect to other vehicle drivers. When the lights are switched off and the ignition is switched on,the instrument and switching lighting (needles and scales) is switch- ed on automatically. As the ambient light be- comes lower, the lighting of the scales is auto- matically reduced and may be switched off en- tirely.
This function is intended to remind the driver to switch on the dipped beam in good time, i.e. when driving through tunnels. WARNING Heavy objects in the car may cause headlights to blinding other road users, distracting their attention and causing serious injuries and deaths! ● To avoid blinding effect on other road users, the headlight beam must be adjusted to the correct position according to the vehicle load. Interior and reading lights, background lighting Press the corresponding button: Switch headlight when driving abroad (tour mode) Switch on the interior lights. Switch the reading light on or off.
If a vehicle is travelling in a country or region passing on the left, the asymmetric headlight dipped beam may blinder oncoming traffic. Therefore, in order to eliminate the glare effect, it is necessary to paste or adjust the headlights. Switch off the interior lights door control function. Switch the reading light on or off. Inter- mediate position Interior lights door control function: the interior lights switch on auto- matically when the vehicle is un- locked, the doors are opened, or the vehicle key is removed from the ig- nition lock. 182.5C1.TRO.74 Tape may be used to block a portion of the head- light glass or the headlight may be adjusted by the qualified workshop.
Volkswagen dealership Lights 77 Rotate adjustment knob 1 to the following position according to vehicle load: Knob po- sition Vehicle load Front seat taken, trunk empty. All seats taken, trunk empty. All seats are occupied, trunk is full. Towing a low load trailer. Only the driver's seat is occupied and the trunk is full. Traction maximum load trailer.