Care & Maintenance Cleaning the Water Tank and Mop Pad 3. Remove the mop pad from the water tank. Water Dispenser Filter Battery Pack Notes: When the vacuum cleaner is charging or not in use, remove the water tank and drain any remaining water to prevent mildew or lingering odor. A worn or damaged mop pad that no longer sticks to the water tank should be replaced to ensure optimal cleaning performance. The water dispenser filter should be replaced if the water tank dispenses water too slowly or becomes clogged. To ensure optimal mopping effectiveness, it is recommended to replace water dispenser filters once every 3 to 6 months depending on water quality and frequency of use.
The vacuum cleaner contains a removable rechargeable lithium-ion battery pack which has a limited number of recharge cycles. After extended use, the battery pack may no longer hold a charge. If this happens, it means the battery pack has reached the end of its life cycle and needs to be replaced. 1. Use your fingers to slide out old water dispenser filters on the left and right sides of each slot. 1. Press down the battery pack release button and slide the battery pack to the right, as illustrated, to remove it. 2. Install the new battery pack. 4. Clean and dry the mop pad. 1. Slide the water tank down to detach it from the smart high torque brush bar. 2.
Insert the new water dispenser filters and check to ensure they are installed correctly. 2. Empty the water tank. 22 23