How to Install Charging Installing the 2-in-1 Charging & Storage Mount Battery Status Indicator Notes: 1. The 2-in-1 charging & storage mount should be installed in a cool, dry place with an electrical outlet nearby. Prior to installing, ensure that there are not any wires or pipes in the space directly behind where the mount will be installed. 2. The bottom of the mounting template sticker should be level and at least 1.03 m from the ground, and its top should have at least 30 cm of clearance above it. 3. Use a power drill with an 8 mm drill bit to drill a hole into each hole marker on the mounting template sticker, then insert a wall plug into each hole. 4.
Align the mounting holes on the 2-in-1 charging & storage mount to the holes on the wall, then attach the mount to the wall using the included screws. Off Blinking On Fully charge the vacuum cleaner before using it for the first time. This will take about 4 hours. The vacuum cleaner cannot be used while charging. Vacuuming at the highest suction level for a prolonged period will cause the battery to heat up, which may increase the charging time. Before charging the vacuum cleaner, it is better to cool it down for 30 minutes.
Low battery Half battery Nearly full Once the vacuum cleaner is fully charged, the indicator will turn off after 5 minutes, and the vacuum cleaner will then enter the energy-saving mode. Fully charged Extended Dock You can simultaneously charge the replaceable battery* when charging the vacuum cleaner on the 2-in-1 charging & storage mount. 30 cm Display Screen The number on the display screen represents the current battery level in a percentage during charging. When the number turns into 100, the battery is fully charged.
1 Extended Dock Charging Plate Charging Port Battery Status Indicator Charging Contacts Ч 2 103 cm Mounting Template Sticker Screw Wall Plug 8 9 * The replaceable battery is not included and purchased separately. Recommended Height: At least 1.03 meters from the ground Charging the vacuum cleaner with the charger Charging the vacuum cleaner on the charging mount 2