Chapter 6 Applied Instructions Example of Communication with Delta servo ASD-A2M 1. Before using the Delta CANopen instruction, mount an AS-FCOPM card in the AS Series PLC (slot 2 only) and be sure to select Delta Special Driver & AS Remote Mode as the working mode for the AS-FCOPM card 2 in the configuration software (HWCONFIG in ISPSoft). Set the baud rate to 125 kbps, 250 kbps, 500 kbps, or 1000 kbps. Figure 1 Function card 2 setting 6_ Figure 2 Working mode selection 2. Connect the AS Series PLC to an ASDA series with a CANopen communication cable as shown in the figure below. (Switch the 120 Ω terminal resistor ON in the AS-FCOPM card to enable the terminal resistor.) 6-895