Ch 2 page 225 TRANSMISSION Preload all follow-on slides (see arrow) and x them with stop plates (1). Figure 725 Insert all pressure controllers (1) with clamping plates (2) into the valve block and fix them with the cylindrical screw (3) Tightening torque: MA = 9.5 Nm Pay attention to the installation position of pressure regulators – plug-in connection (see arrow). Figure 726 Legend 1= Pressure regulator Y1 - Clutch 2= Pressure regulator Y2 - Clutch 3= Pressure regulator Y3 - Clutch 4= Pressure regulator Y4 - Clutch 5= Pressure regulator Y5 - Clutch 6= Pressure regulator Y6 - Clutch Figure 727 IInstall the adjusting screws and assemble the intermediate sheet (1) and valve block (2).
(S) Adjusting screws 120702-00081 WARNING It is forbidden to reinstall the intermediate sheet after opening of the bolted connection duct plate/valve block. In case of repair a new intermediate sheet is generally to be installed! Figure 728 SHOP MANUAL