Ch 2 page 77 TRANSMISSION Remove all screw plugs with O-ring (1). Figure 173 Fasten the input shaft (2) with the lifting strap and slightly preload it with lifting tackle until the snap ring in the annula grooves of the input shafts (1 and 2) is with no pressure. By means of a screwdriver press the snap ring on the 4 mounting holes (see arrows Figure 174) into the annula grooves of the input shaft (1) from clutch V until the input shaft (2) can be pulled out. (S) Lifting strap Figure 174 Legend: 1 = Input shaft Clutch V 2 = Input shaft 3 = Snap ring SB 76 (green) Figure 175 Remove the O-rings (1) and the snap ring (2). Figure 176 SHOP MANUAL