Control functions TIP 2. Push the “RESET” button to change the hour setting, and then push the “SE- LECT” button. The minute digits will start flashing. 3. Push the “RESET” button to change the minute setting, and then push the “SE- LECT” button. The clock starts when the “SELECT” button is released. G To switch the speedometer, odometer, and tripmeter displays between kilometers and miles, select the odometer mode “ODO”, and then push the “SELECT” button for at least 10 seconds while the snowmobile is stopped.
G To switch the barometer display between hectopascal “hPa” and inches of mercury “inHg”, select the barometer mode “BARO”, and then push the “SELECT” button for at least 3 seconds while the snowmobile is stopped. TIP The clock must be set again when the battery is disconnected. Display brightness control This function allows you to adjust the bright- ness of the meter display to suit the outdoor lighting conditions. To adjust the display brightness 1. Turn the main switch to the off position. 2. Push and hold down the “SELECT” but- ton. Clock To set the clock: 1. Push the “SELECT” button and “RESET” button simultaneously until the hour digits start flashing. 1. “SELECT” button 2.
“RESET” button 3. Display brightness level 3. Turn the main switch to the on position, and then, after 5 seconds, release the “SELECT” button. 4. Push the “RESET” button to select the desired display brightness level, and then push the “SELECT” button. The normal display returns when the “SELECT” but- ton is released. 1. “SELECT” button 2. “RESET” button 11