3 i5601E Digital Display i5601E Setup & Navigation The i5601E was Setup at the factory with the keys assigned and locked as shown on the previous pages of this manual. This mode is the default mode and allows start up and operation of the engine. It serves many applications quite well. The i5601E Digital Display unit has many additional features and capabilities. This section of the book shows the use of some of these features. Changing the basic Setup is typically accomplished in one of two ways. 1. Go to the systems menu and alter basic selections. 2. Enable the right arrow key (5) on the basic screens to allow changing of the data shown in the default displays.
To enter the “Main Menu” press and hold key 5 until the menu appears. To move around the menus, use the hot keys at the bottom of the screen. The function of a particular hot key changes from screen to screen to whatever is most appropriate for the given screen. Keys 1 2 3 4 5 NOTE: The following are Hot Key choices: © 2011 Yanmar Marine International • Rev. 2.0 Yanmar Electronic Control Systems Technical Manual 3:7