3 i5601E Digital Display calibration Trim Calibration The i5601E Digital Display with software revision 4.0 or higher can be used to calibrate the trim senders on BY2 Unlimited engines with Stern Drives. Use the information on page A:1 to select the “MAIN MENU” and then select “CALIBRATION”. When the Calibration screen is on the display select “TRIM”. MAIN MENU CALIBRATION ALARMs / DIAGs MONITOR SETTINGS CALIBRATION FACTORY SETTINGS USER SETTINGS TROLLING TRIM BACK BACK The trim screen allows selection of the sender type or sender calibration. First assure the sender type matches the drive.
Mercury drives use a resistive sender “RES” while Yanmar ZT350 drives use the Smart Stick sender SM STK. To select a setting other than the one that is displayed use the up and down arrow keys to position the arrow in front of the line you wish to change and pres the right arrow key. Use the “+” and “-” keys to change the selection and then use the up down arrow keys to move to the next line or the back key to exit. TRIM TRIM SNDR TYPE RES SNDR CAL SNDR TYPE SM STK SNDR CAL © 2011 Yanmar Marine International • Rev. 2.0 Yanmar Electronic Control Systems Technical Manual 3:33 BACK BACK