1. COMMON MODEL INFORMATION outboard is the vertical distance from the horizontal contact surface of the transom bracket to the anti- ventilation plate. If the outboard installation height cannot be achieved, adjust boat transom height. USING THE TRANSOM MOUNT DRILL FIXTURE Verify no damage will occur when the motor mounting holes are drilled. Look for any structural impediments such as bulkheads, braces, fuel cells, bilge pumps, or floor sections before drilling. Ensure there is adequate space for the bolt, washer and transom support plates (if applicable) to bear on a flat surface.
TRANSOM HEIGHT ADJUSTMENT If the transom is too low or too high, or needs to be modified to accommodate the width of the outboard motor(s), contact the boat manufacturer and follow their recommendations for corrective action. If mounting two outboard motors, be sure the installation height is identical for both. Some boat manufacturers June require different mounting heights. Consult your boat manufacturer for specifics on your boat. B 0 c o Dm Description Part No. I Transom Mount Drill Fixture I 07MPZ-ZV301OC I See TRANSOM DRILLING section in applicable model-family chapter for additional information regarding use of the transom mount drill fixture. Date of Issue:
June 2003 0 2001-2003 American Honda Motor Co., Inc. 1-23