OPERATION EXPLANATION OF COMPONENTS SETTING CORRECT TIME 1. Press display selector button (4) to display the time. After 5 seconds, the display will return to the frequency display and the time cannot be corrected. If this happens, press display selector button (4) again. 2. Press time adjustment button (8) and adjust the hour and minute. H button: Adjusts hour (advances one hour each time it is pressed) M button: Adjusts minute (advances one minute each time it is pressed) If the H or M button are kept pressed, the time will advance continuously until the button is released. SET button:
Sets to start of hour (when it is pressed, the minute returns to 00) If the minute display is between 0 and 05, and the SET button is pressed, the minute reading will return to 00. If it is pressed when the minute display is between 55 and 59, the minute display will return to 00 and the hour will advance by 1. Example 10:05 10:00 10:59 11:00 10:26 10:26 Press the H, M, and SET buttons to set to the correct time. ANTENNA If the receiving wave is weak or generates noise, extend the antenna. If the wave is too strong, adjust the sensitivity by retracting the antenna.
NOTICE When transporting the machine or parking it in a garage, always fully retract the antenna to avoid the possibility of breakage. PRECAUTIONS WHEN USING G To ensure safety, always keep the sound to a level where it is possible to hear outside sounds during opera- tion. G If water gets into the speaker case or radio, it may lead to an unexpected failure, so be careful not to get water on the equipment. G Do not wipe the scales or buttons with benzene, thinner, or any other solvent. Wipe with a soft dry cloth. Use a cloth soaked in alcohol if the equipment is extremely dirty. G When the battery is replaced, the settings for the preset buttons are all cleared, so set them again. 3-39