PRODUCT OVERVIEW LCD control (hourmeter, display brightness, battery voltage) You can switch (scroll) between displays by pressing the buttons on the bottom. Figure 1 Switching screens by pressing the right button (Pressing the left button switches the screens in the opposite direction.) Press the power switch. Engine hour ( >300 min -1 ) Scroll After 4 seconds, the LCD shows the hourmeter. Pressing the right button on the bottom of the LCD shows the temperature display. This feature is not available on this engine. Coolant temperature Pressing the right button again shows the LCD brightness settings. To set the brightness of the backlight:
Backlighting Brightness Press the left button continuously and the digits of the LCD start flashing. In this condition, press the right button to decrease the brightness and the left button to increase the brightness. (The brightness changes in 6 steps of 20 %.) Push and hold (display will blink when ready) 1 2 3 Scroll 100, 80, 60, 40, 20, 0 (value will be set after 3 seconds) To set the desired brightness, do not touch the buttons for 3 seconds. Note: Continuously pressing means holding the button for approx. 2 seconds. Oil pressure Next, press the right button to show the pressure display. Battery voltage This feature is not available on this engine.
Return to hourmeter 051899-00EN00 Press again to show the battery voltage. Pressing the button once more returns the display to the initial hourmeter. Figure 11 20 YM Series Operation Manual