. OPERATION EXPLANATION OF COMPONENTS HEAD LAMP beam and low HANDRAIL AND STEP WARNING BACK-UP LAMP 3 - 7 This head lamp ( 4) lights up th e road and the area a machine is travel ing at night. Tur n the lamp on and off with Use bea To p revent yourself from slipping and falling when getting on or off the machine, always o bserve the following precautions. If you fall, there is danger of injury. W hen getting on or off the machine, always face the ma chine and maintain at least three-point contac t (both feet and one h and, o r both hands a nd one foot) w ith the handrail and step s to ensure that you support y ourself. B efore getting o n or off the m achine, check the handr ails and steps.
If there is any oil, grease, or mud o n them, wipe i t off im mediately. In addition, repai r any damage and tighte n any loose bolts. ces where there are no anti-slip pads. D o not get on or off the machi ne while holding tools. N ever climb ont o the engine h ood, covers, or other pla ces where there are no anti-sli p pads. Use the handrail and steps (5 ) when getting on or o ff the machine to carry out inspection or operation. The se are at two places on th e left and right at the REAR COMBINATION LAMP On rear combina , the turn signal lamp in the direction of turning fl ashes when the tu rn signal lev operated.
If th e hazard lam p switch is tu rned ON, both the left and right turn signal lamps flash at t he same time. This back-up lam p (7) lights u p when the machine t Wh en the gear s hift lever is s et to "R", it lights up to ensure that the machine is traveling in revers TAIL LAMP nd tail lamp are built into this tail lamp (8). The stop lamp a nd tail lamp a re built into this tail la Stop lamp: Light s up to inform following vehicles th at brake has been depress ed and machine wi ll stop. Tail lamp:Tail lam p lights up when lamp switch is tu rned ON. he machine at night. These display the p osition of the rear of t