TM2361 (24JUN08) 9015-15-30 450DLC Excavator Operation and Tests 062608 PN=474 Sub-System Diagnostics • Arm out pressure sensor (B50) MCF output involved: Power dig solenoid (Y24) • Arm in pressure sensor (B51) • Boom up pressure sensor (B52) Pushing and holding down the momentary power dig • Bucket curl pressure sensor (B54) switch (S7) connects MCF terminal B4 to ground. • Bucket dump pressure sensor (B55) When the MCF detects ground this ground, the MCF • Travel right pressure sensor (B56) sends current out terminals A7 and A23 to power dig • Travel left pressure sensor (B57) solenoid (Y24), energizing the solenoid. MCF output involved:
Boom mode solenoid (Y23) As long as the power dig switch is held down, the solenoid stays energized, but only for a maximum of 8 Putting boom mode switch (S20) in the ON position seconds. A timer inside the MCF limits the amount of provides a ground to terminal B2 on the MCF. When time the power dig solenoid is energized. the MCF detects this ground, and if any of the following conditions are met, the MCF will send a Releasing the power dig switch resets the internal current out terminals A6 and A10, energizing boom timer and allows the power dig solenoid to be mode solenoid (Y23). energized for another 8 seconds maximum when the switch is pushed again.
• Digging mode selected in work mode menu • No travel operation. MCF detects NO signal from Travel Control—The travel control automatically either travel pressure sensor (B56 or B57) energizes the power dig solenoid when a travel • Hydraulic function activated. MCF detects signal function is operated. 9015 15 30 from one or more circuit pressure sensors (B33, B45, B50, B51, B52, B53, B54, or B55) MCF inputs involved: For hydraulic information on this circuit, see Boom • Travel right pressure sensor (B56) Mode Circuit Operation. (Group 9025-05.) • Travel left pressure sensor (B57) Power Dig Solenoid (Y24) (SG): When energized, the MCF output involved:
Power dig solenoid (Y24) power dig solenoid supplies back-pressure to the main relief valve to increase main relief pressure and When travel is detected by one or both travel pressure provide more power for all functions. For hydraulic sensors (B56 and B57), the MCF energizes power dig information,see Main Relief and Power Digging Valve solenoid (Y24). At the same time, the MCF sends a Circuit Operation. (Group 9025-05.) signal to the ECM to increase engine speed approximately 100 rpm. See Engine Control—Travel The power dig solenoid (Y24) is controlled by the Speed Increase Control previously in this theory of following systems: operation.
• Power Dig Control During travel operation, the MCF activates travel alarm • Travel Control (H4). For more information, see Travel Alarm Circuit • Auto-Power Lift Control Theory of Operation. (Group 9015-15.) • Counterweight Removal and Installation Control Auto-Power Lift Control—When operating the boom up Power Dig Control—Temporarily energizes the power function and NOT operating the arm in function will dig solenoid to increase the main relief pressure. cause the MCF to temporarily energize the power dig solenoid. MCF input involved: Power dig switch (S7) Continued on next page CS33148,00008EB –19–28APR06–13/15