John Deere 450DLC — Boom Mode Switch Off, Boom Will Not Raise Machine Off Ground Diagnostic Procedure

Diagnostic Information Boom Mode Switch Off, Boom Will Not Raise Machine Off Ground Diagnostic Procedure NOTE: If boom mode switch, under left armrest is in on position, it is normal that boom will not raise machine. Check position of this switch before starting this diagnostic procedure. –1/1 TM2361 (24JUN08) 9025-15-22 450DLC Excavator Operation and Tests 062608 PN=772 1 DTC Check See Reading Diagnostic Trouble Codes With Monitor Display. (Group 9015-20.) See Reading Diagnostic Trouble Codes With Service ADVISORDiagnostic Application Are any of the following DTC displayed? • 11989.03 See Boom Mode Solenoid (SC) Valve Feedback Current High.

(Group 9001-10.) • 11989.04 See Boom Mode Solenoid (SC) Valve Feedback Current Low. (Group 9001-10.) YES: Diagnose and repair as required to clear displayed DTC. Diagnostic procedure complete. NO: Go to Actuating Pilot Pressure Check. – – –1/1 2 Actuating Pilot Pressure Check Key on, use monitor service menu to display Swing / Attachment Control Pilot Pressure. See Monitor Service Menu Operation. (Group 9015-16.) NOTE: To use gauge to check pressure, see Control Valve Spool Actuating Pilot Pressure Test. (Group 9025-25.) Run engine at fast idle and lower boom to raise one side of excavator off ground. Monitor pilot pressure. Is maximum pilot pressure approximately 3.9 MPa? YES:

Go to Boom Mode Selector Switch Check. NO: Diagnose pilot pressure problem at pump or valve. If pilot pressure is low, adjust or replace valve. Perform Pilot Pressure Regulating Valve Test and Adjustment. (Group 9025-25.) – – –1/1 9025 15 22 3 Boom Mode Selector Switch Check Key on, use monitor service menu to display Pump 1 Delivery Pressure. See Monitor Service Menu Operation. (Group 9015-16.) Put boom mode switch in off position. Run engine at fast idle and lower boom to raise one track off ground. Record maximum pressure. Does delivery pressure exceed 31.0 MPa? YES: Diagnostic procedure complete. NO: Go to Boom Overload Relief Check. – – –1/1