TM2361 (24JUN08) 9025-25-3 450DLC Excavator Operation and Tests 062608 PN=863 Tests Hydraulic Oil Cleanup Procedure Using Portable Filter Caddy SPECIFICATIONS NOTE: Filtering time for hydraulic tank is 0.089 minute Hydraulic Oil Tank Capacity 321 L approximate x number of liters (0.33 minutes x number of 85 gal approximate gallons). Hydraulic Oil Tank Filtering 30 minutes approximate Time 4. Leave filter caddy operating for the next step. Hydraulic System Capacity 560 L approximate 148 gal approximate 5. Start the engine and run it at fast idle. Hydraulic System Filtering Time 90 minutes approximate IMPORTANT:
For the most effective results, SERVICE EQUIPMENT AND TOOLS cleaning procedure must start with the smallest capacity circuit then JDG1724A Super Caddy proceed to the next larger capacity JT05679 Hose 3.7 m (12 ft) x 3/4 in. ID 100R1 Hose with 3/4 M circuit. NPT Ends (2 used) JTO5751A Suction Wand 6. Starting with the smallest capacity circuit, operate JTO5750A Discharge Wand each function through a complete cycle. 1. Install new return filter elements. Repeat procedure until the total system capacity has circulated through filter caddy seven times. NOTE: For a failure that creates a lot of debris, Each function must go through a minimum of three remove access cover from hydraulic tank.
complete cycles for a thorough cleaning of oil. Drain hydraulic tank. Connect filter caddy suction line to drain port. Add a minimum of 19 Specification L (5 gal) of oil to reservoir. Operate filter caddy Hydraulic System—Capacity................................. 560 L approximate and wash out the hydraulic tank. 148 gal approximate Hydraulic System—Filtering Time...............................................................90 minutes approximate IMPORTANT: The minimum ID for a connector is 13 mm (1/2 in.) to prevent cavitation NOTE: Filtering time for complete hydraulic system is of filter caddy pump. 0.158 minute x number of liters (0.6 minute x number of gallons).
Filtering time for machines 2. Put filter caddy suction and discharge wands into with auxiliary hydraulic functions must be hydraulic tank filler hole so ends are as far apart as increased because system capacity is larger. possible to obtain a thorough cleaning of oil. 7. Stop the engine. Remove the filter caddy. 3. Start the filter caddy. Check to be sure oil is flowing through the filters. 8. Install new return filter elements. Operate filter caddy until all the oil in hydraulic tank 9. Check hydraulic oil level. See Check Hydraulic Oil has been circulated through the filter a minimum of Level. (Operator’s Manual.) four times.
Specification Hydraulic Oil Tank—Capacity................................ 321 L approximate 85 gal approximate Hydraulic Oil Tank—Filtering Time...............................................................30 minutes approximate TX04577,00000E3 –19–26APR06–1/1 9025 25 3 SPECIFICATIONS Hydraulic Oil Tank Capacity 321 L approximate 85 gal approximate Hydraulic Oil Tank Filtering Time 30 minutes approximate Hydraulic System Capacity 560 L approximate 148 gal approximate Hydraulic System Filtering Time 90 minutes approximate SERVICE EQUIPMENT AND TOOLS JDG1724A Super Caddy JT05679 Hose 3.7 m (12 ft) x 3/4 in.
ID 100R1 Hose with 3/4 M NPT Ends (2 used) JTO5751A Suction Wand JTO5750A Discharge Wand