John Deere 450DLC — Power Dig Solenoid Valve (port SG) Test and Adjustment

TM2361 (24JUN08) 9025-25-18 450DLC Excavator Operation and Tests 062608 PN=878 Tests 9. Adjust the solenoid valve (H) as needed. a. Loosen nut (J). IMPORTANT: Turning adjusting screw out too far may cause oil leakage because the O-ring –UN–20JUN96 has come off its seat. b. Turn adjusting screw (I) in to increase pressure setting; turn adjusting screw out to decrease T101709 pressure setting. The length from end of adjusting screw to nut must not exceed the specified length. Specification H—Solenoid Valve Solenoid Valve Adjusting Screw— I—Adjusting Screw Pressure Change.....................................

0.069 MPa approximate per 1/4 J—Nut turn 69 kPa approximate per 1/4 turn 0.69 bar approximate per 1/4 turn 10 psi approximate per 1/4 turn End of Adjusting Screw-to-Nut— Length............................................................................... 2 mm maximum 0.079 in. maximum c. Hold adjusting screw and tighten nut. Specification Solenoid Valve Adjusting Screw-to-Housing Nut—Torque.................................................... 3.0 N•m 27 lb-in. 9025 25 18 10. Check the pressure setting again. LD30992,00002B1 –19–05JUN06–5/5