24 Charge Lamp This warning lamp lights up if the charging system fails while the engine is running. When the starter switch is turned ”ON” with the engine off, the lamp lights up, and when the engine gets started, the lamp goes out. LCD Display for Normal Operation Fuel gauge 3 CAUTION To avoid personal injury: Before adding fuel, be sure to stop the engine. Be sure to keep open fl ame away from the machine. Otherwise a fi re may be caused. NOTE: If there is disconnection or failure in the charging system when the key is turned to ”RUN”, the following symbol will appear. With the starter key at the ”RUN” position, the fuel remaining in the fuel tank is indicated in the block.
Oil Lamp The engine oil pressure warning lamp lights up due to failure of the lubricating system with the engine running. When the starter switch is turned ”ON” with the engine off, this lamp lights up, and when the engine starts, the lamp goes out. If the lamp stays on with the engine running, stop the engine and check the engine oil level. NOTE: If there is disconnection, failure or breakdown in the lubricating system when the key is turned to ”RUN”, the following symbol will appear. (1) Fuel gauge (A) ”Empty” (B) ”Full” IMPORTANT: If the fuel gauge indicator is near the ”E” or the ”FUEL” message appears, add fuel as soon as possible.
If the indicator is near ”E” and the machine runs on a slope, the engine may run out of fuel and get interrupted. Glow Lamp With the starter key at the ”RUN” position, the engine’s preheat status is indicated. NOTE: When the starter switch is turned to the ”RUN” position, the engine will be preheated for a given period of time and the lamp will turn on. The above indication appears momentarily when the engine is started, but it does not mean any trouble. (This is because the oil charge sensor output becomes unstable when the engine is started.) The symbol appears momentarily as the engine starts. This is not an error. Fuel supply The following functions are helpful when adding the fuel.
The fueling progress can be monitored by a buzzer sound.