SAFETY INSTRUCTIONS 4.When the front loader is raised, the risk of the tractor tipping over is greater, and the braking effect at the rear axle may also be reduced. Adapt your driving style and ensure adequate ballasting at the rear. For additional loading, we recommend attaching the Fendt 870 kg additional weight at the three-point link - fit wheel weights and fill the tyres if necessary. 5.Keep a safe distance from high-voltage cables. 6.When on public roads, bring the front loader into the transport position and secure it. Keep a maximum distance of 3.5 m between the implement and the centre of the steering wheel.
If the forward projection exceeds 3.5 m, appropriate measures must be taken to guarantee safe traffic conditions (e.g. use people on foot acting as guides or mirrors at road junctions). Transporting equipment or materials with a front loader working implement, e.g. a scoop, is not permitted when travelling on public roads. 7.Danger from unintended lowering of the front loader. Always secure hydraulic lever at the end of operation. Before leaving the tractor, completely lower the front loader to the ground. 8.For safety reasons the front loader should be mounted and removed by one person only, the driver himself.
9.Always keep hands away from the crushing and cutting areas while parts may still be moving. 10.Detach the front loader with the attached implement (bucket, fork) only on firm and level ground. Always use the supports provided. 11.The front loader must be parked and secured in such a way as to prevent unauthorised persons or children from causing it to tip over. 12.When mounting the front loader, connect all hydraulic connections including the auxiliary return, if equipped in this way. Always connect hydraulic hose for cylinder load pressure to +. Take great care not to confuse connections since this may cause accidents through reversed functions, e.g. lifting instead of lowering.
Before fitting the multiple coupler, remove the load from hydraulic hoses and unplug rear hydraulic connections, lower the power lift and operate only via EPC. Hydraulic fluid interflow can create danger from unintentional equipment motion. Leaving the tractor Text-module 1.Make sure the tractor is properly secured against running off (parking brake, wheel chocks). Switch off the engine and apply the hand brake! 2.Remove the ignition key and lock the cab if necessary. 3.Never leave the tractor unattended while the engine is running. 4.Never leave the cab while the tractor is in motion. 5.Completely lower the mounted implement before leaving the tractor.
ETNum-list Mounted and trailing equipment Text-module 1.Only attach implements and trailers using the prescribed devices. 2.Use only trailers which comply with the country-specific regulations. Do not exceed maximum vertical bearing load. Ensure that the tractor-trailer brake system is functioning correctly. 3.Take special care when hitching trailers or implements! 4.Secure trailers and implements to prevent them rolling. Make sure that detached implements and components are safely parked. 5.Be sure all protection devices are correctly attached and in the safety position before operating the tractor.
6.When using the power lift, always remain well outside the travel range of the three-point link attachment! ETNum-list PTO operation Text-module 1.Always switch off the engine, before fitting or removing the drive shaft. The PTO shaft must be in 0-position. 2.During PTO operations, allow no-one in the vicinity of the rotating PTO or drive shaft. 3.Make sure drive shaft and PTO are equipped with protective guards and sleeves. 4.After switching off the PTO, the attached implement may continue running due to the flywheel mass. In this case, do not go near the implement. Approach it only when it has come to a complete standstill.
5.When the drive shaft is removed, cover the PTO shaft with its protective cap. ETNum-list ETNum-list 10